Pace-edwards JR Series Toyota Tundra StepSide Manuel d'utilisateur télécharger pdf (Page 5)

Side rails have a rubber spacer on the end caps, at the tailgate end, to establish the correct

spacing to the tailgate (1/16”) and to prevent the tailgate from striking the side rails when

closing. Press the rail tightly against the closed tailgate.

Shims may be required to maintain a horizontal top surface on the rails. Peel and stick the

shims to the back side of the rail brackets (or the side that will be against the truck).

Shims are provided in two thicknesses. Shims may need to be stacked on each other to

create the right thickness. Repeat the same process on each side.

Place the four clamps (Fig. 7A) over the rail brackets located on the underside of the rails.

Locate the LOWER groove of inner clamp bracket onto the lip of rail bracket.

Rotate the outer clamp bracket clockwise to tighten rail downward against bed rail.

Tighten bolt securely.

(Adjust pressure against tailgate by moving rails forward or backward as needed prior to

ﬁ nal tightening of clamps.)

Repeat for all clamps.

Ensure that the canister is snug up against the front sill of the truck bed. At this time you

need to completely tighten the Canister stop (Installed in Step 3, Fig. 3A) as well.

HARDWARE USED:

OUTER & INNER RAIL

CLAMPS x 4

1/4” FLAT WASHER x 4

1/4” LOCK WASHER x 4

RAIL CLAMP BOLT x 4

INSTALLATION INSTRUCTIONS

DO NOT TIGHTEN OVER 120-INCH POUNDS!

RAIL

BRACKET

INNER CLAMP

BRACKET

BOLT, FLAT

WASHER &

LOCK WASHER

OUTER CLAMP

BRACKET

FIG. 7A

STEP 7: INSTALL & FASTEN THE CLAMPS

PLASTIC SHIMS x 8

Locate the sweep seals (rubber weather strips) on the rails.

Open the provided 303 brand protectant sponge pack (ﬁ nd

it adhered to the underside of the top cover) and wipe the

underside of the sweep seal and the top of the wear strip.

Extend the cover to the tailgate. Use an Allen wrench if

needed to carefully draw out the sweep seal (seal should be

angled outwards toward the cover – not rolled in toward the

bed rail). (Fig. 8A)

Proper care and placement of the sweep seal will ensure

smooth operation of the cover. Alcohol, petroleum based or

silicon-based cleaners such as Armor-All

should be avoided

and ARE NOT recommended for our covers

STEP 8: LUBRICATING & PLACING THE SWEEP SEALS

COVER/

FABRIC PANEL

SWEEP SEAL

WEAR STRIP

RAIL

FIG.8A

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Pace-edwards JR Series Toyota Tundra StepSide Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Pace-edwards JR Series Toyota Tundra StepSide