Pace-edwards JR Series Toyota Tundra StepSide Manuel d'utilisateur télécharger pdf (Page 4)

STEP 4: INSTALL CHANNEL

Peel the foam backing and attach it to the bottom of the channel.

Bolt the Canister Channel assembly to the rails using the Black #10-32 x 3/4” Flat head

Screw provided. (Figure 4A & 4B)

Black #10-32 x 3/4”

Flat head Screw

Rail

Canister

Channel

#10 Washer

#10-32 Nut

Closed Cell

Foam

Truck

Bed Sill

Canister Channel

Completed Assembly

HARDWARE USED:

CLOSE CELL FOAM x 1

#10-32 x 3/4” FLAT HEAD

SCREW x 2

#10 FLAT WASHER x 2

#10-32 NUT x 2

Canister

Slide canister and rail assembly against the front cab sill of the truck bed. Remove the support(s) under the

canister so that the canister and rails rest ﬁ rmly on the sides of the truck bed.

STEP 5: REPOSITIONING CANISTER

Open the rail box along the length of the box; lift rails

out to avoid scratching the rail surface on the package

staples.

The side rails are marked “left” and “right” (left is the

driver’s side of the truck).

With the tailgate closed, place the side rails in position on

the truck bed.

Install the tailgate end of the pull strap to the underside of

the drivers side rail using the #8-32 x 3/4 machine screw

located at the tailgate end on the underside of the rail.

STEP 6: INSTALL TAILGATE END OF PULL STRAP

HARDWARE USED:

PULL STRAP x 1

(TAILGATE END)

JACKRABBIT SERIES TUNDRA STEPSIDE

1 2 3 4 5 6 7 8

Pas de commentaire

Pace-edwards JR Series Toyota Tundra StepSide Manuel d'utilisateur Page 4