Pace-edwards JR Series Nissan Frontier Crew Cab Extra Short Bed Manuel d'utilisateur télécharger pdf (Page 4)

Place the four clamps (Figure 6) over the rail brackets located on the underside of the rails

and snug up but do not tighten yet.

Rotate the outer clamp bracket clockwise to tighten the rail against the truck bed rail.

With the tailgate closed, slide the rails

to establish the correct spacing to

the tailgate. The rails have a rubber

spacer on the end caps, at the tailgate

end, to establish the correct spacing

(1/16”) and to prevent the tailgate from

striking the side rails when closing.

Press the rail tightly against the closed

tailgate.

Measure the distance between the

rails at the canister and tailgate. This

distance should be 53-5/16” to allow

your cover to operate properly. Once

everything is square tighten the Rail

clamps completely.

JACKRABBIT

SERIES FRONTIER

STEP 5: INSTALLING CLAMPS

Install the tailgate end of the pull strap to the underside

of the drivers side rail using the #8-32 x 3/4 machine

screw located at the tailgate end on the underside of

the rail.

STEP 4: INSTALL TAILGATE END OF PULL STRAP

HARDWARE USED:

PULL STRAP x 1

(TAILGATE END)

HARDWARE USED:

OUTER & INNER RAIL

CLAMPS x 4

1/4” FLAT WASHER x 4

1/4” LOCK WASHER x 4

RAIL CLAMP BOLT x 4

DO NOT TIGHTEN OVER

120-INCH POUNDS!

RAIL

BRACKET

INNER CLAMP

BRACKET

BOLT, FLAT

WASHER &

LOCK WASHER

OUTER CLAMP

BRACKET

UTILIRACK

FIG. 6

Locate the sweep seals (rubber weather strips) on the rails.

Open the provided 303 brand protectant sponge pack (ﬁ nd

it adhered to the underside of the top cover) and wipe the

underside of the sweep seal and the top of the wear strip.

Extend the cover to the tailgate. Use an Allen wrench if

needed to carefully draw out the sweep seal (seal should be

angled outwards toward the cover – not rolled in toward the

bed rail). (Fig. 7A)

Proper care and placement of the sweep seal will ensure

smooth operation of the cover. Alcohol, petroleum based or

silicon-based cleaners such as Armor-All

should be avoided

and ARE NOT recommended for our covers

STEP 6: LUBRICATING & PLACING THE SWEEP SEALS

COVER/

FABRIC PANEL

SWEEP SEAL

WEAR STRIP

RAIL

FIG.7A

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Pace-edwards JR Series Nissan Frontier Crew Cab Extra Short Bed Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Pace-edwards JR Series Nissan Frontier Crew Cab Extra Short Bed