Pace-edwards JR Series Toyota Tundra Manuel d'utilisateur télécharger pdf (Page 5)

STEP 7: INSTALLING DRAIN TUBES

Locate the sweep seals (rubber weather strips) on the rails.

Apply Pace Edwards’ UV Protectant (or 303 brand protectant)

to a rag and wipe the underside of the sweep seal and the top

of the wear strip.

Extend the cover to the tailgate. Use an Allen wrench if

needed to carefully draw out the sweep seal (seal should be

angled outwards toward the cover – not rolled in toward the

bed rail). (Fig. 6A)

Proper care and placement of the sweep seal will ensure

smooth operation of the cover. Alcohol, petroleum based or

silicon-based cleaners such as Armor-All

should be avoided

and ARE NOT recommended for our covers

STEP 6: LUBRICATING & PLACING THE SWEEP SEALS

INSTALLATION INSTRUCTIONS

You have now completed the installation of your JackRabbit Series hard tonneau cover. If you have any

questions please do not hesitate to call us at: (800) 338-3697 and ask for our technical service department.

COVER/

FABRIC PANEL

SWEEP SEAL

WEAR STRIP

RAIL

First ensure that the washer is in place on the drain tube end being inserted into the canister (This will prevent

water leakage). Test ﬁ t the drain tube to determine the length you want to trim it. Always caution on the long side.

Trim the end that will be inserted through the truck bed with the wire cutters or a utility knife.

With the cover opened, insert the drain tube ﬁ ttings into the pre-drilled holes on the underside of the canister by

pushing them in place from under the canister. Drain tube should click into place.

Place the other end of the drain tube through the plastic/ rubber access port or through the pre-drilled holes in the

ﬂ oor or the front wall of the truck bed.

Place the Top Cover on the canister and install

with the two black Top Cover screws into the top

cover mounting blocks. (we recommend that you

use a thread locking adhesive like Loctite® on the

screws)

Retract the cover to the fully open position.

Attach the 4” Velcro strip onto the Velcro strip

already attached to the pull strap.

Pull the pull strap over to the driver’s side rail and

remove the tape from the 4” Velcro strip.

Then apply the Velcro strip onto the underside of

the rail at your desired position.

This will hold the pull strap off of the ﬂ oor and out

of the way when cargo is being stored in the truck

bed.

FIG.6A

DRAIN TUBE FITTING

STEP 8: ATTACHING TOP COVER & VELCRO TO PULL STRAP

HARDWARE USED:

4’ VELCRO STRIP

BLACK TOP COVER

SCREW x 2

NOTE: If the OE access ports are located on the front wall of the truck bed you should ensure that the drain-

tubes are inserted and directed down so water ﬂ ows out of the truck.

Washer

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Pace-edwards JR Series Toyota Tundra Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Pace-edwards JR Series Toyota Tundra