Pace-edwards PowerGate LK370 Ford Super Duty (1999-2005) Manuel d'utilisateur télécharger pdf

2400 Commercial Blvd., Centralia WA 98531 • (800) 338-3697 • www.paceedwards.com

Thank you for choosing products by Pace Edwards...

Ford F-150/250 Light Duty &

Super Crew - 1997 to 2010

Ford Super Duty - 1999 to 2005

Part # LK370

Long Wire

Harness

Short Wire

Harness

Wire

Ties

Wire

Taps

INSTALLATION INSTRUCTIONS

LK370-08/09

STEP 1: Install PowerGate™

Note: If your truck is equipped with an OEM manual door lock, install the PowerGate

with the OEM manual lock in the unlocked position.

With tailgate open, remove the screws from the tailgate access panel using a Torx

T-30 screwdriver. Remove the 10mm nut on the left side of the handle assembly.

In order to get the powergate in the correct position you will need to temporarily

remove the lock bar rod from the plastic rod retainer and move it aside. This will

make it possible to maneuver the powergate assembly underneath the bar. Once

the powergate is in place you can reconnect the lock bar rod into the rod retainer.

Install PowerGate lock through the tailgate opening and over stud on left side of

handle assembly. (see Fig. 1) Replace the 10mm nut and tighten. Slide the lock

bolt with your ﬁ ngers to insure that there is no interference and that the bolt works

properly. Adjust if necessary.

STEP 2: Route the Wire Harness & Relay Loom Wires

Route the short wire harness through the drain hole in the bottom of tailgate and connect it to PowerGate. Plug the long wire

harness to the short wire harness. Route the long wire harness underneath the driver’s side of the truck to the ﬁ rewall.

Using the Relay Loom on the drivers side of the engine compartment thread the purple and gray wire loom through the ﬁ re wall of

the truck. (Try to follow OEM wire routes whenever possible.)

STEP 3: Locate and Connect Wires

Plug the purple and gray wires to the wire taps. Return to the engine compartment and plug the long wire harness from the

PowerGate unit to the Relay loom with the green and blue wires. (Testing will be done later to insure appropriate connections)

Inside the engine compartment locate the positive post next to the fuse panel on the fender well. Open the cap for the positive post,

remove the nut and slip the red wire with the fuse holder on that post. Re-install the nut and close the cap. Find the ground-wire

bolt on the driver side fender well and remove it. Install the black wire to the ground-wire bolt and make sure you get all of the black

ground wires that were there when you started, re-install the bolt.

Return to the cab and make sure the door locks and tailgate lock work. Test the lock by locking and unlocking your power door

locks. If the lock/unlock direction of the PowerGate does not correspond with the direction of your door locks then switch the purple

and gray loom wires where they are attached to the door lock wires and test again.

STEP 4: Secure Wires

Install tailgate access panel. Secure all wires with wire ties provided so that there are no loose, dangling ends.

PowerGate

LK370 Unit

Relay

Loom

Purple &

Gray wires

Green &

Blue wires

Red wire w/ fuse

holder &

black ground-wire

2008-2010 F150/F250 Light

Duty & Supercrew

1997-2007 F150/250 Light

Duty & Supercrew

2004- 2005 Super Duty 1999- 2003 Super Duty

Route the wires through the

ﬁ rewall on the drivers side.

Locate the blue w/ green

and gray w/ brown wires

inside the drivers side kick

panel. Install one blue wire

tap on the blue w/ green

stripe wire and one blue wire

tap on the gray w/ brown

stripe wire.

Run wires under the dash

across to the passengers’ side

of the truck carefully remove

the passengers’ side kick-

panel to ﬁ nd the wire harness

with the pink w/black wire and

the red w/orange wire. Install

one blue wire tap on the pink

w/black and one blue wire tap

on the red w/orange wire for

these trucks.

Run wires under the dash across

to the passengers’ side of the truck

carefully remove the passengers’

side sill plate near the base of the

seat belt to ﬁ nd the wire harness

with the red w/ orange stripe and

pink w/ black stripe wires. Install

one blue wire tap on the red w/

orange stripe wire and one blue

wire tap on the pink w/ black

stripe wire.

Route the wires through the

ﬁ rewall on the drivers side.

Locate the red w/ orange

stripe and pink w/ black

stripe wires under the dash

above the steering column.

Install one blue wire tap on

the red w/ orange stripe

wire and one blue wire tap

on the pink w/ black stripe

wire.

Fig. 1

Part # LK370 1

Résumé du contenu

Page 1 - Part # LK370

2400 Commercial Blvd., Centralia WA 98531 • (800) 338-3697 • www.paceedwards.comThank you for choosing products by Pace Edwards...Ford F-150/25

Commentaires sur ces manuels

Pas de commentaire

Pace-edwards PowerGate LK370 Ford Super Duty (1999-2005) Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Pace-edwards PowerGate LK370 Ford Super Duty (1999-2005). Pace-Edwards PowerGate LK370 Ford Super Duty (1999-2005) User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Pace-edwards PowerGate LK370 Ford Super Duty (1999-2005)