Pace-edwards PowerGate LK280 Chevy _ GMC Full Size (2007-2010) Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

LK 280 • 2007-CURRENT • SILVERADO/ GMC

STEP 1 : REMOVE THE HANDLE ASSEMBLY FROM THE TAILGATE

!! NOTE: BE SURE TO PROTECT ALL PAINTED SURFACES OF THE TRUCK !!

Remove the plastic bezel around the truck tailgate handle. To do this ﬁ rst remove the bottom bolt on the inside of the

tailgate and then carefully pry the bezel clips out of the slots in tailgate. (Figure 1) (Clips are tight, protect your paint.

Auto parts stores offer a door panel removal tool that helps remove this)

Rotate the plastic locking clips holding the threaded lock arms

to the truck tailgate handle and pull the threaded lock arms

out of the truck tailgate handle assembly. Remove the two top

bolts holding the truck tailgate handle in place. Lift the truck

tailgate handle out of tailgate.

STEP 2 : INSTALL POWERGATE

Run the short (black and white) wire harness with the two

blank wires up into the tailgate drain slot in the bottom drivers

side of the tailgate and pull up to the tailgate handle area.

Crimp the two female bullet connectors to these black and

white wires and then plug them into the actuator connectors.

(It does not matter which one.)

The PowerGate will be mounted between the back (cabside)

of the tailgate and the truck tailgate handle. Insert and hold the Powergate plate and truck tailgate handle against

the inside of the tailgate and start one of the top bolts in the truck tailgate handle (A helping hand makes this much

easier). Tighten loosely and continue to install the other top bolt. (If you have the factory manual locking handle make

sure it is in the unlock position (Figure 1) and the locking mechanism attached to the truck tailgate handle assembly

is in the lowered position (not pictured)). Attach the tailgate threaded lock arms and snap the plastic locking clips back

into place. (Do not reinstall the plastic bezel around the tailgate handle yet)

TOOLS REQUIRED:

Crimp tool Door panel removal tool (optional)

½” or 13mm socket

PACKAGE CONTENTS:

SHORT WIRE

HARNESS

LONG WIRE

HARNESS

FEMALE BULLET

CONNECTORS WIRE TIES

POWERGATE

ACTUATOR

WIRE T-TAPS

WIRE RELAY

HARNESS

Figure 1

Pry out bezel clips holding plastic

bezel around the tailgate handle

If you have the factory manual locking

handle make sure it is in the unlock position

1 2

INSTALLATION INSTRUCTIONS 1

Résumé du contenu

Page 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONSLK 280 • 2007-CURRENT • SILVERADO/ GMCSTEP 1 : REMOVE THE HANDLE ASSEMBLY FROM THE TAILGATE!! NOTE: BE SURE TO PROTECT AL

Page 2

STEP 4 : REINSTALL THE BEZEL AROUND THE TAILGATE HANDLE Mount the bezel by pushing its clips back into the tailgate. (Figure 7)Install the bottom bolt

Commentaires sur ces manuels

Pas de commentaire

Pace-edwards PowerGate LK280 Chevy _ GMC Full Size (2007-2010) Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Pace-edwards PowerGate LK280 Chevy _ GMC Full Size (2007-2010). Pace-Edwards PowerGate LK280 Chevy _ GMC Full Size (2007-2010) User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Pace-edwards PowerGate LK280 Chevy _ GMC Full Size (2007-2010)