Pace-edwards BL Ford Ranger Manuel d'utilisateur télécharger pdf (Page 5)

INSTALLATION INSTRUCTIONS

STEP 6: INSTALLING CLAMPS

HARDWARE USED:

Before shimming and installing the rail clamps make sure the canister is centered between

the truck bed rails.

Slide the front adjustable clamp shims (Figure 5A) down the rails 6-12” from the canister.

Place the plastic shim along the truck bed rail as shown in Figure 5A to shim up the

Adjustable Clamp Shim Bracket.

Loosen the bolt on the front clamp shim and slide the bracket up against the truck bed

rail and plastic shim. Then tighten the bolt so the clamp shim is held tight in place. (Figure

5A).

Slide the front clamp rail grips (Figure 5B) 1” from the adjustable clamp shim on both the

left and right side rails.

Slide the rear adjustable clamp shims (Figure 5A) down the rails 6-12” from the tailgate.

Place the plastic shim along the truck bed rail as shown in Figure 5A to shim up the

Adjustable Clamp Shim Bracket.

Loosen the bolt on the rear clamp shim and slide the bracket up against the truck bed rail

and plastic shim. Then tighten the bolt so the clamp shim is held tight in place. (Fig. 5A).

Slide rear clamp rail grips 1” from the adjustable clamp shim on both the left and right

rails.

Assemble the pivot arms to the clamp rail grips and snug the bolts on the clamps so that the

rails rest ﬁ rmly against the truck bed. (Figure 5B) Close the tailgate and position the rails

with a 1/16” gap from the tailgate.

Make sure the between the rails measurement is 53-5/16” at both the canister and tailgate.

This distance should be the same (53-5/16 inches) at both the canister and tailgate ends of

the rails to allow your cover to operate properly.

Once everything is square tighten the rail clamps completely.

DO NOT TIGHTEN OVER 120-INCH POUNDS!

Inside of

Truck Bed

Pivot Arm

Clamp Bolt

(tighten for

proper ﬁ t)

Clamp

Rail Grip

Rail

Adjustable Clamp

Shim Bracket for

both front a& rear

Adjusting

Bolt

Plastic

Shims

FIG. 5A

FIG. 5C

ADJUSTABLE CLAMP SHIM

ASSEMBLY x 4

PLASTIC SHIM x 4

RAIL SPEED CLAMP

ASSEMBLY x 4

FIG. 5B

Inside of

Truck Bed

Rail

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Pace-edwards BL Ford Ranger Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Pace-edwards BL Ford Ranger