Pace-edwards BL Ford Ranger Manuel d'utilisateur télécharger pdf (Page 3)

INSTALLATION INSTRUCTIONS

You will need one or two support pieces (We suggest using the top of the box the Bedlocker was shipped in) to set

in the truck bed.

Set the support piece approximately one foot from the cab.

Set the Canister on the support(s) in the truck bed. The canister should be resting on the support piece, centered

in the truck bed, raising the top of the canister above the bed rails by 2-3 inches.

Hold onto the ribbed blanket and cut the zip tie.

(Do not let the blanket roll back on itself or the underside on the

ﬁ rst three ribs can damage the visual surface of the other rolled

ribs).

Remove all of the vinyl sheeting protecting the blanket.

Pull the blanket out about 1 foot from the canister and let it hang.

STEP 4: PLACE CANISTER IN TRUCK BED

Support Piece

STEP 3: INSTALL WIRING HARNESS

(If the optional wire harness Part# BL1120 is used, you may want to tape it to the main

harness to ease having to pull them through the stake pocket separately).

From inside the truck bed push the long wire harness end without the plug through the

stake pocket on the drivers side of the truck and out the underside of the truck bed box.

Leave approximately one foot of slack inside the box for mounting the electronics.

Route the wire harness under the truck and to the battery in the engine compartment.

Attach the fuse holder to the end of the Red/positive wire.

(Do not attach to the battery yet.)

Secure the harness with wire ties provided after slack from the canister has been taken

out.

HARDWARE USED:

WIRE HARNESS x 1

ZIP TIES x 5

STEP 2: INSTALL L-SHAPED FRONT SILL

Inside the Truck Bed, remove the two bolts from each of

the rear window guard tie downs.

Peel the liner off the back of the foam on the back of the

L-shaped Front Sill. Line the holes in the L-shaped front

sill up with the top holes in the tie downs. Re-install the

bolts and tighten completely.

You may use the 3 tek screws to further secure the L-

shaped front sill if necessary.

OPTIONAL

HARDWARE USED:

12 x 1” TEK SCREW x 3

Window Guard Tie Down

L-shaped front sill

Top Bolt in Truck Bed

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Pace-edwards BL Ford Ranger Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Pace-edwards BL Ford Ranger