Pace-edwards BL Toyota 07-Current Tundra Manuel d'utilisateur télécharger pdf (Page 3)

STEP 2: INSTALL WIRING HARNESS

Use the #30 Torx Bit to remove the Front Track (against the cab) of the Deck Rail System from the truck bed if it is

installed on the truck.

You will need one or two support pieces (We suggest using the top of the box the Bedlocker was shipped in) to set

in the truck bed.

Set the support piece approximately one foot from the cab.

Set the Canister on the support(s) in the truck bed. The canister should be resting on the support piece, centered

in the truck bed, raising the top of the canister above the bed rails by

2-3 inches.

Hold onto the ribbed blanket and cut the zip tie.

(Do not let the blanket roll back on itself or the underside on the

ﬁ rst three ribs can damage the visual surface of the other rolled

ribs).

Remove all of the vinyl sheeting protecting the blanket.

Pull the blanket out about 1 foot from the canister and let it hang.

STEP 3: PLACE CANISTER IN TRUCK BED

Complete Canister

Assembly

Top Cover

Rails

(left & right)

Hardware

Pack

Clamp

Pack

Drain

Tubes

Support Piece

(If the optional wire harness Part# BL1120 is used, you may want to tape it to the main

harness to ease having to pull them through the stake pocket separately).

From inside the truck bed push the long wire harness end without the plug through the

stake pocket on the drivers side of the truck and out the underside of the truck bed box.

Leave approximately one foot of slack inside the box for mounting the electronics.

Route the wire harness under the truck and to the battery in the engine compartment.

Attach the fuse holder to the end of the Red/positive wire.

(Do not attach to the battery yet.)

Secure the harness with wire ties provided after slack from the canister has been taken

out.

INSTALLATION INSTRUCTIONS

Rails Come in a

separate Box.

PACKAGING CONTENTS:

HARDWARE USED:

WIRE HARNESS x 1

ZIP TIES x 5

DO NOT USE A KNIFE TO OPEN

THE RAIL BOX.

OPEN THE RAIL BOX ALONG

THE LENGTH OF THE BOX

AND LIFT RAILS OUT TO AVOID

SCRATCHING THE SURFACE OF

THE RAILS ON THE PACKAGE

STAPLES.

CAUTION!

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Pace-edwards BL Toyota 07-Current Tundra Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Pace-edwards BL Toyota 07-Current Tundra