Pace-edwards JR Colorado_ Canyon Crew Cab XSB Manuel d'utilisateur télécharger pdf (Page 5)

5INSTALLATION INSTRUCTIONS

You have now completed the installation of your JackRabbit hard tonneau cover. If you have any questions please do not

hesitate to call us at: (800) 338-3697 and ask for our technical service department.

STEP 6: INSTALLING DRAIN TUBES

First ensure that the washer is in place on the drain tube end being inserted into the canister (This will prevent

water leakage).

With the cover opened, insert the drain tube ﬁ ttings into the pre-drilled holes on the underside of the canister by

pushing them in place from under the canister. Drain tube should click into place.

Place the other end of the drain tube through the grommet or through the pre-drilled holes in the ﬂ oor or the front

wall of the truck bed.

Place the Top Cover on the canister and install with

the four long Top Cover screws.

Tighten the screws completely. Do not over tighten.

Foam is provided to close up the front of the top

cover if needed.

Retract the cover to the fully open position.

Attach the 4” Velcro strip onto the Velcro strip

already attached to the pull strap.

Pull the pull strap over to the driver’s side rail and

remove the tape from the 4” Velcro strip.

Then apply the Velcro strip onto the underside of

the rail at your desired position.

This will hold the pull strap off of the ﬂ oor and out of the way when cargo is being stored in

the truck bed.

Washer

DRAIN TUBE FITTING

STEP 7: ATTACHING TOP COVER & VELCRO TO PULL STRAP

HARDWARE USED:

4’ VELCRO STRIP

BLACK TOP COVER

SCREW x 4

FOAM

1 2 3 4 5 6 7 8

Pas de commentaire

Pace-edwards JR Colorado_ Canyon Crew Cab XSB Manuel d'utilisateur Page 5