Pace-edwards BL Ford Explorer Sport Trac Manuel d'utilisateur télécharger pdf (Page 4)

BEDLOCKER

EXPL SPORT TRAC

STEP 5: INSTALLING CLAMPS

HARDWARE USED:

Install the rear clamps as shown (Figure 5A) using the OE holes at the rear of the truck

bed.

Locate the lower groove of rear clamp block onto the lip of the rail bracket.

Tighten against the truck bed rail.

The ¼-20 bolt at the top of the clamp can be used to level the rail by turning the bolt out to

apply pressure against the rail.

Tighten bolts securely. (Adjust pressure against tailgate by moving rails forward or

backward as needed prior to ﬁ nal tightening of clamps.)

With rear clamps in place, make sure the canister is centered from side-to-side.

Using the two black screws provided, screw through the rails into the front rail block

(Figures 3A & 5B).

If needed, add shims (included) on front rail block to level the rails.

FIG. 5A

Rail Bracket

Leveling Bolt

Rear Clamp Block

Rear Clamp

Washer, Lock

Washer & Bolt

Front Rail Block

Screw

FIG. 5B

1/4-20 x 3/4”

STOP BOLT x 2

FRONT RAIL BLOCK

SCREW x 2

1/4” FLAT WASHER x 2

1/4” LOCK WASHER x 2

REAR CLAMP

BLOCK x 2

PLASTIC SHIMS x 4

STEP 4: INSTALLING RAILS

The machined end of the rail attaches to the

canister.

You will need to lift the hanging portion of the

ribbed blanket and thread it in the rail while sliding

the rail into the rail grip mounted to the ends of

the canister (the underside of the blanket ribs

need to nest on the gear).

Make sure both ﬂ anges of rail slide into the rail

grip.

Push the rails forward against the canister.

Complete for both left and right rails.

Remove the support or stand and lower the

canister and rail assembly onto the front sill and

rails of the truck bed.

Slide the entire canister and rail assembly forward

against the cab end of the truck bed.

Close the tailgate and pull the rails

only toward it leaving approximately 1/8” gap between the end of the rails and

the tailgate.

Be sure to hold the canister in place to ensure it does not move from the front truck bed sill with the rails while

adjusting the gap of the rails to the tailgate.

Rail Grips

Rail

Flange

Ribbed

Blanket

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Pace-edwards BL Ford Explorer Sport Trac Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Pace-edwards BL Ford Explorer Sport Trac